Skip to main content

GENERATIONS

Search This Blog

Installation and use of Mysql Workbench beginner

on July 12, 2020

Get link
Facebook
X
Pinterest
Email
Other Apps

Simple installation of mysql workbench

Use of Mysql workbench

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

Post a Comment

Popular Posts

AC Light switch using relay

There are alot of circuits on how to do this. Most of them require you to place the photosensor between the base (B) of the transistor and the Emitter (E). But i have found this method not to be working well so i decided to place the photosensor between the resistor and the power supply (DC). So how is this method different. First the photosensor is already sending power even at low lighting. So if the source is 12v, that means that power though the photosensor under low light is approximately 8v. This means that 8v won't be able to course an effect on the relay since the relay is 12v based. When a bright light is put in a close distance with the photosensor, There will be low resistance on the photosensor hence the desired power which will follow to the relay The point where I have labeled as " AC power out" is the off point at default on the relay. What I mean is that the point with AC power out is the one is not connected inside of the relay at first. I have used a ...

Mosfet and capacitor switch

In the usual circuits, the capacitor is not included in. So why did i add a capacitor. if u have ever built a touch switch using only a mosfet, u do know that when u touch on the off wires the mosfet will gain power over time and light up again. Which can be somewhat annoying. But when u add a capacitor as seen above. When u apply a plus or add the wires temporarily or use a push switch( this switch should not lock when pressed.), u charge the capacitor and when u release the capacitor still has charge hence it is still providing power and working as a line which joins both the gate(G) and the source(S) of the mosfet. REMEMBER; When u try to touch using this method it will not work coz the capacitor will need alot or current and voltage for it to charge at a small amount of time which ur fingers can't provide. So when u press the push switch on the gate(G) Drain(D) part. This will discharge the capacitor and provide power to the gate(G) at the same time

HIDEN DRIVE BECAUSE IT DOES'NT HAVE A DRIVE LETTER

so one day i plug in my hard drive and to my wonder. one of the partition is not showing up in file manager. One partition is called " anima " and the other is called "files" I freak out wondering what the hell is going on. why is "files" partition not showing yet anime is showing I open disk management and truly the partition is there but file manager is not showing it. And to make matters worse. when i click on the other partition "anime" the open option appears. But to the other drive "files", the open option is in gray. As am pocking around. i see this option which says assign drive letter. so i just click on it. So i assign a drive letter to files partition The drive is now being seen. I don't know how i un signed the drive letter but it turns out this is a great way of hiding your drive partition

Powered by Blogger

kimbugwe rogers